NAUTIC FILL 1 is a polyester adhesive for professional use in the construction of yachts, boats, canoes, caravans and other laminate structures. NAUTIC FILL 1 is an assembly adhesive that strongly joins the connected elements together and has good resistance properties. A carefully chosen thixotropy makes it possible to apply it in thick layers (even up to 3 cm), ensuring good adhesive properties with different types of substrates.

SAFETY DATA SHEET

TECHNICAL DATA SHEET

Substrates:

• polyester laminates,
• epoxy laminates,
• plywood,
• wood,
• rigid polyurethane and PVC foams.

Caution: The adhesive should not be applied directly on one-component acrylic and nitrocellulose products.

Surface preparation:

• polyester and epoxy laminates: degrease, dry grind P80 – P120, degrease again with a silicone remover,
• plywood, wood: dry grind P80 – P120, then remove dust.

Mixing ratio:

NAUTIC FILL - 100 parts by weight,

Hardener - 1 to 2 parts by weight.

Supplementary products:

Hardener - methyl ethyl ketone peroxide (e.g. METOX 50).

Application life after mixing with the hardener:

NAUTIC FILL 1: 10 to 20 minutes at 20°C (hardener: 2 %).

Curing time:

NAUTIC FILL 1: 1.5 to 2 hours at 20°C (hardener: 2 %).

Coatability:

Polyester finishing filler, polyester spray filler, acrylic primers.

Procedure:

Mix the components thoroughly. Observe the required amount of hardener. Apply a layer not thicker than 30 mm with a trowel. The viscosity of the cured surface improves the adhesion of the following layers. If needed, it may be removed with an NC solvent. Minimal application temperature: +10°C.